How To Install Inside Mount Plantation Shutters

 

Preparation

Before getting started, make sure you have the tools that you need:

  • Cordless drill
  • Phillips head screwdriver bit
  • Stanley Knife
  • Leveler
  • A step ladder if necessary

 

Organising Your Shutters

Find an open space on the floor where you can unpack and assemble your shutters, ideally in front of the window. Shutters usually come in at least two boxes - a smaller box with the frame, and a larger box that contains up to two shutter panels.

Look for the red tape on your boxes. This marks where your hardware (mounting screws, hinge pins, locking screws, and hinge packers) have been packed. Open your box by cutting carefully along the tape with a knife and removing the packaging.

Set your panels aside and look at your frame. The frame comes in 4 pieces and is labelled left, right, top and bottom. Lay each piece on the floor mirroring how you will lift the frame onto the window.

Now You're Ready To Assemble

If you’re using a Z frame with a sill, your bottom frame needs to be screwed on.

Depending on the design of your shutters, you may need to install a T post. The top and bottom of your T post will be labelled - in this case, “B” for bottom. Once you’ve assembled the outside of your frame, place it in position and take care to screw into the existing holes.

Lift the finished frame into the window. You need to temporarily fix it into place by using the pre drilled mounting holes to screw in the top of the frame. Frames can be heavy and the top left and right screws support the corners. Don’t completely tighten these screws yet.

With your frame mounted, time to put in your shutters. Your shutters come with hinges already attached. You’ll find the matching half of the hinge attached to the frame.

Work left to right and lift your panels into place. Drop in the hinge pins to lock you shutters in place.

Before screwing in the rest of your frame, look at your shutters and adjust left and right so that your panels line up.

Your panels are rigid, but your frame is not until it is fixed in place. You can flex your frame slightly to get your shutters to sit perfectly square.

Make any necessary adjustments and once you’re happy, fix the frame in place by tightening the screws and using the rest of the predrilled holes. The perfect shutter may sometimes require some fine tuning. To move a panel slightly up or down, loosen the hinge screws. Once you’re happy with the position, screw in the locking screw.

Hinge packers also allow fine adjustment. Loosen the panel screws and slide in behind the hinge.

The final step is to insert your screw caps.

And if you’ve chosen an L frame, for a truly professional look, you may want to fill any gap around the frame.

Congratulations!

Your shutters are installed and ready to use!

If you’re having any difficulties installing your shutters, you’ll find helpful guides and lots more help on our website. However don’t hesitate to get in touch if there’s anything we can help with info@shuttersdept.com.au and 1300 161 650.

1 4

Was this article helpful?